Impact Moling

Impact moling is used to install pipes or cables under roads, driveways, or footpaths, all without the need to dig an open trench. It's a great option when you need to lay pipes in built-up areas or places where digging would cause too much disruption. Whether it's water, gas, or telecom lines, impact moling gets the job done quickly and with minimal fuss.

An impact mole uses a pneumatic hammer to drive a steel tool through the ground. The mole creates a borehole as it moves and that bore is used to pull the pipe or cable into place. The hammer action breaks up the soil and keeps the mole moving, allowing you to get pipes underground without traditional trenching. It's a fast and efficient way to handle utility installations.

Our impact moles come in sizes from 45mm up to 145mm, covering most small-bore utility installations. Whether you're laying a water pipe or telecom cable, these sizes should fit your needs. If you're not sure what size is right for your project, just let us know and we can help you choose the best fit.

Yes, to power the mole, you'll need a compressor. The compressor provides the pneumatic force that drives the mole through the ground. Depending on your project, you may also want to use launch kits to guide the mole into place and locators to track its progress underground, helping with accuracy and keeping things on track.

Absolutely. Impact moling equipment is compact and easy to transport, so you can quickly move it between sites or access remote areas. The setup is simple, too - just connect the compressor, position the mole and you're good to go. It's a quick way to get started without the need for extensive prep or large crews.