To enable our standard hoist cages and industrial lifts to be configured for maximum safety and efficiency, we offer you a range of accessories for most hoists. These include:
Landing Protection Panels – panels are fitted either side of the landing gate to prevent site staff from touching the hoist cage as it travels past, or stops at the landing. These are secured to the hoist vertical pipe superstructure and are fitted during the hoist installation.
Landing Infill Plates – infill plates are installed to bridge the gap between the hoist superstructure and the site landings. The use of landing infill plates also restricts the gap between the hoist cage floor edge and landing edge to below 50mm as required by BS7212.
Foundation Steel Plates – designed to avoid the necessity to fix the hoist base assembly down to concrete floors, or where the hoist is placed on a soft surface. We can supply a steel plate to go under the hoist base which is bolted down to the plate. The standard FSP plate size is 4000 x 2500 x 40mm and weighs 3200Kg, which is sufficient to absorb the upwards forces in the event of a hoist striking the bottom buffers.
Landing Bridges – where the hoist is mounted away from the building or scaffolding landing edge, we can supply and install a landing bridge. This will provide a safe walkway between the hoist cage and landing. The landing bridges are equipped with protection panels at the hoist end and full length handrails and toeboards to minimise the risk of items falling from the bridge. Landing bridges are the same width as the hoist cage and available in lengths up to 6.0 metres.
Top Hats – These are available to be fitted to the roof of passenger goods hoists over the cage roof trapdoor. They allow the safe transportation of long items within the cage / top hat, without the possibility of the load falling from the hoist cage.
Pipe Carriers – These can be fitted to goods only hoists and enable scaffold poles and similar equipment to be carried safely.